Krone BiG X 770-3 - Lifting Unit Menu Area

Info centre "EasyTouch"
182
8.2.4.4 Lifting unit menu area
In field mode, the current control type status of the lifting unit is displayed in the drive data
information section (III). The actual height of the lifting unit and the corresponding setpoint
pressure or setpoint height are displayed in the settings information section (IV) in the Lifting
unit menu area.
5 6
7 8
B C
D
BX850849
IV
III
2
3
1
Fig. 126
Show
Item
Designation
Explanation
(1)
Actual height of the lifting unit in cm
or inch.
If the lifting unit distance control is active, the
actual height is hidden.
(2)
Setpoint pressure in percent
For lifting unit ground pressure control
Setpoint pressure is percentage of the front
attachment's dead weight. It is adjustable
between -6% (front attachment sways above
the ground) up to max. 70% (front attachment
presses on to the ground with 70% of its
dead weight).
Setpoint height in cm or inch
For lifting unit position control
Setpoint height in percent
For lifting unit distance control
Setpoint height in % of the control path of the
sliding skid sensors. Can be set between
10-90%.
(3)
Status displays of the lifting unit
control types
• Status displays, see page 175.
Changing the setpoint pressure or setpoint height (2)
• To reduce the setpoint value, press the
7
key.
• To increase the setpoint value, press the
8
key.
Alternatively, you can also make the setting with the incremental encoder, see page 163.

NOTE
The setpoint pressure and/or setpoint height can also be stored using the multi-function lever,
see page 567. If the setpoint value is changed using the keys on the terminal, the value is
saved directly, which means that there is no need to save using the multi-function lever.