Start-up – Spout extension
500
14.1.5 Removing the spout end piece (8- and 10-row)
Fig. 431
Disconnect the spout end piece (2) and the spout basic (5):
• Use a suitable sling to secure the spout end piece (2) from falling.
• Unscrew the nuts (4) and remove the cover cap (3).
• Disconnect the plug connection (1).
Fig. 432
• Disconnect the hydraulic hoses (3) from the hydraulic lines.
• Unscrew the screws (4, 5) at the coupling point.
• Separate the spout end piece (1) from the spout basic (2) set it down safely.
To Next Page
Loading...
