Driving and Transport
534
17.9 Applying the parking brake
Risk of injury due to the unsecured machine rolling away!
If the unsecured machine starts moving, there is a risk of people being struck or run over.
• After pressing the "Parking brake" key or when exiting the machine, check the status of the
parking brake in the display.
NOTE
If the "Parking brake" key is pressed while driving, the travelling gear is braked and, when the
machine has stopped, the parking brake is applied.
The parking brake is automatically released or applied under certain operating conditions and
can be manually actuated by pressing the "Parking brake" key, see page 136.
17.10 Switching off the engine
Engine will be damaged by heat accumulation!
If the engine is immediately switch off after operation under load, the heat accumulation,
caused by the lack of cooling, may damage the engine.
• Leave the engine running for three minutes at a low idling speed before switching off the
engine.
Fig. 475
• Brake the machine to a standstill.
• Actuate the key (2) to lower the front attachment fully to the ground.
• Turn the ignition key (1) anti-clockwise to the
position.
• Switch off all release switches.
To Next Page
Loading...
