Start-up - Maize mode
464
12 Start-up - Maize mode
This chapter describes the conversion from grass mode to maize mode.
Risk of injury from unexpected movement of the lifting unit!
When working on the lifting unit or when opening/closing the stop cocks on the lifting cylinders,
the lifting unit and the installed components may move unexpectedly. As a result, people may
be injured.
• To secure the lifting unit from unintentionally lowering, close the stop cocks.
• To reach the stop cocks safely, swivel open the tool box, go under the machine and actuate
the stop cocks.
• Install a corn conditioner, see page 471.
• Setting the rear wall of the discharge accelerator rotor "maize", see page 594.
• Move the three-way stopcock at the lifting unit to the "Maize" position.
• Replace tension spring of the pendulum frame with a hydraulic cylinder, see page 485.
• Turning the conveyor bars on the pre-compression roller, see page 711.
• Mount the grain capture sheets on the intake unit, see page 488.
• Replace the chopping blade (grass blade → maize blade), for chopping drum with 20, 28,
36 blades see page 694, for chopping drum with 40, 48 blades see page 701readjust
chopping blades and/or replace for chopping drum with 40, 48 blades.
• Replace counterblade (standard → special), see page 708.
• Adapt the spout extension to the front attachment type, see page 496.
• Adapting additional weights to the front attachment type and setting tyre pressure, see page
515.
• Setting the rear axle suspension.
• Carry out machine settings in the terminal, see page 190.
– Operating mode EasyCollect
– Type of EasyCollect front attachment
– Number of rows and row spacing
– Lifting unit mode
– Number of blades of the chopping drum
– Operating mode and sensitivity of the automatic steering system
• Calibration, see page 264.
– Lifting unit
– Corn conditioner
– Pendulum frame/Cutting height
To Next Page
Loading...
