Start-up
447
10 Start-up
10.1 Check before Start-up
NOTE
Compliance with the stipulated checks on the machine significantly increases the safety and the
service life of the machine.
A machine with established defects must not be started.
• If it is established that the machine has defects, shut down the machine and eliminate these
defects or have them eliminated by technicians.
General information:
– Visual inspection of the machine:
No liquid under the vehicle, no sagging or detached cables, plugs or hoses, etc.
– Check the safety devices for damage and, if required, replace.
– Check that the screws are tight.
– Ensure that the front attachment has been correctly mounted and fitted with the
corresponding safety devices.
– Lubricate the machine.
– Ensure that the wheel chocks are at hand and ready to use.
– Ensure that the platforms, steps and standing spaces are clean and in a proper condition.
– Check the pre-cleaner for dirt and clean with compressed air if necessary.
Engine/engine compartment:
– Check that the engine compartment is clean.
– Check the engine oil level.
– Check the engine coolant level.
– Check the fuel level.
Central lubrication system:
– Check the central lubrication system.
To Next Page
Loading...
