Commissioning
442
9 Commissioning
This chapter describes the assembly and set-up work on the machine which may be performed
by qualified technicians only. The note "Personnel qualification of the qualified technicians"
applies, see chapter Safety, "Basic safety notes".
WARNING
Risk of injury or damage to the machine due to faulty initial operation
If the initial operation is carried out incorrectly or incompletely, the machine may present
defects. As a result, people may be injured or killed or the machine may be damaged.
• Initial operation must only be carried out by authorised technicians.
• Read in full and follow the “Personnel qualification of the technicians”, see chapter “Basic
safety instructions”.
WARNING!
If the basic safety instructions are not followed, people may be seriously injured or
killed.
• To avoid accidents, the basic safety instructions in the chapter Safety must have been
read and followed, see chapter Safety "Basic safety instructions".
WARNING!
If the safety routines are not adhered to, people may be seriously injured or killed.
• To avoid accidents, the safety routines in the chapter Safety must be read and followed,
see chapter Safety "Safety routines".
9.1 Checks before starting up the machine for the first time
NOTE
Compliance with the stipulated checks on the machine significantly increases the safety and the
service life of the machine.
A machine with established defects must not be started.
• If it is established that the machine has defects, shut down the machine and eliminate these
defects or have them eliminated by technicians.
• Before starting up the machine, carry out the inspections listed below and checks from the
maintenance table "Every 10 hours, at least daily".
General information:
– Check the machine for leakages of oil, water, fuel and refrigerant.
– Check the machine for sagging and detached cables, plugs and hoses.
– Check the safety devices for damage and, if required, replace.
– Ensure that the front attachment has been correctly mounted and fitted with the
corresponding safety devices.
– Ensure that the wheel chocks are at hand and ready to use.
– Ensure that the platforms, steps and standing spaces are clean and in a proper condition.
To Next Page
Loading...
