Krone BiG X 770-3 - Direct Cut Header

Info centre "EasyTouch"
202
8.2.5.4 Direct cut header
Set the operating mode to direct cutting system
5 6
7 8
B C D
BX500049
Fig. 146
• You can use the incremental encoder to choose the operating mode setting. The selection
box is highlighted in colour.
• Press the incremental encoder to jump to the selection box.
• You can use the incremental encoder to set the operating mode of the direct cutting
system
.
• Press the incremental encoder to accept the setting and to exit the selection box.
• To exit the settings mask, press the
D
key or the key on the incremental encoder.