Krone BiG X 770-3 - Removing;Installing the NIR Sensor for Moisture Measurement

Start-up - Maize mode
479
12.3.1 Removing/installing the NIR sensor for moisture measurement
Removing the NIR sensor
Fig. 395
• Unscrew the wing nuts (1) and remove with the disc.
• Open the protective lid (2) on the spout.
Fig. 396
• Loosen and disconnect the plug connection (3) of the connector cable for the
NIR sensor (1).
• Unscrew the wing nuts (2) and remove with the discs.
• Remove the NIR sensor (1).