Start-up - Grass mode
451
11 Start-up - Grass mode
This chapter describes the conversion from maize mode to grass mode.
• Installing the grass channel, see page 458.
• Setting the rear wall of discharge accelerator "Grass mode", see page 594.
• Move the three-way stopcock to position "Grass"
• Replace the hydraulic cylinder of the pendulum frame with a tension spring (in reverse
sequence), see page 485.
• Turning the conveyor bars on the pre-compression roller, see page 711.
• Grain capture sheets on the intake unit, see page 488dismounting grain capture sheets
• Replace the chopping blade (maize blade → grass blade), for chopping drum with 20, 28,
36 blades see page 694, for chopping drum with 40, 48 blades see page 701readjust and/or
replace chopping blades for chopping drum with 40, 48 blades.
• Replace counterblade (special → standard), see page 708.
• Adapt the spout extension to the front attachment type, see page 496.
• Adapting additional weights to the front attachment type and setting tyre pressure, see page
515.
• Setting the rear axle suspension,
• Setting the machine settings in the terminal, see page 186.
– operating mode Easy Flow
– Front attachment type Easy Flow
– Lifting unit mode
– Number of blades of the chopping drum
• Calibration, see page 264.
– Lifting unit
– Pendulum frame/Cutting height
To Next Page
Loading...
