Krone BiG X 770-3 - Menu 3-6 Corn Conditioner Calibration

Info centre "EasyTouch"
290
8.6.7 Menu 3-6 Corn conditioner calibration
The discharge chute must always be calibrated when
– a corn conditioner has been removed or installed again.
– the control unit KMC3 has been replaced.
– the actual roller distance deviates significantly from the target roller distance.
5 6
7 8
B C D
BX500621
5 6
7 8
B C D
BX500069
1
Fig. 221
Prerequisites:
– The diesel engine is switched off.
– The machine is prevented from rolling away.
– Release switch "road/field" is set to field mode.
– Release switch "traction drive" is switched off.
– Release switch "maintenance" is switched off.
– The seat switch is actuated (the driver's seat is occupied)
– Switch "quick-stop console" is not actuated = OFF
– Switch "quick-stop manual operation" is not actuated = OFF
Main menu 3 Maintenance is active.
• Using the incremental encoder, choose menu 3-6 Corn conditioner calibration.
• Press the incremental encoder.
The display shows the menu level Calibration of corn conditioner.
Displaying unfulfilled switching-on conditions and disturbances, see page 255.