Info centre "EasyTouch"
435
8.17 Recording the characteristic line
The characteristic line can be recorded with an existing flow sensor only.
The characteristic line must be recorded whenever there is a change to the silage additives unit
(e.g. change to the injection point or nozzle) or silage additives, as the recording of the
characteristic line specifies the minimum and maximum silage additives quantity which can be
set on the terminal.
The quick coupling must not be opened while the characteristic line is being recorded.
CAUTION!
If used improperly, the chemicals used in the silage additives unit may cause damage to health.
• The safety instructions issued by the silage agent manufacturer must be followed.
Notice
Collect any silage additives which run out while the characteristic line is being recorded and
dispose of them correctly.
1. Switch on continuous operation (see chapter "Continuous operation") until liquid runs out of
the nozzle.
2. Press the
(
) key to switch off the silage additives unit.
3. Start recording the characteristic line by pressing the
( ) key.
Characteristic line recording automatically ends after approx. 1-2 min.
Notice
Characteristic line recording can be cancelled at any time by pressing the (
To Next Page
Loading...
