Krone BiG X 770-3 - Entering Correction Factor Directly

Appendix – CropControl System
71
1.4.7.5 Entering correction factor directly
If counterweighing has not yet been carried out for an order, a correction factor can be entered
directly. However, this factor does not necessarily reflect the characteristics of the order.
Notice
While the factor for an order is entered, another order may run simultaneously.
Prerequisite:
– The order for which the factor should be modified is started or paused, refer to chapter
Operation, “Operating CropControl System with Installed CropControl TC Sync System via
KRONE CCI 200 Operating Terminal”, “Creating Control Mobile Order and Performing
Counterweighing”, “Creating Order”.
– No counterweighing has not yet been started and stopped for the order.
CC8000037
Fig. 73
• Press .
CC8000041
Fig. 74
• The input mask to enter the factor opens.
• Enter the factor.