Krone BiG X 770-3 - Autocalibrate; Entering Calibration Factor Directly

Appendix – CropControl System
65
1.4.6.4 Entering Calibration Factor Directly
If no counterweighing has been carried out for an order, a correction factor can be entered
directly. However, this correction factor does not necessarily reflect the characteristics of the
order.
Notice
While the correction factor for an order is entered, another order may run simultaneously.
Prerequisite:
– The order for which the correction factor should be modified is started or paused, refer to
chapter Operation, “Operating CropControl System with Installed CropControl TC Sync
System via Operating Terminal KRONE CCI 200”, “Creating CCI 200 Order and Performing
Counterweighing”, “Creating Order”.
– No counterweighing has yet been started and stopped.
CC001002
CC001003
Fig. 62
Notice
The softkey for the list of counterweighings does not appear for orders which have never
been started.
• To open the list of counterweighings, press .
The input mask to enter the factor opens.
• Press
and enter the new factor. The factor changes.
1.4.6.5 AutoCalibrate
If AutoCalibrate is used, the weights of the counterweighings are entered automatically in the
list of the counterweighings. They can be modified or deleted manually.