Info centre "EasyTouch"
272
After exchanging the sensors and actuators, the ISOBUS steering system must be recalibrated.
Observe the sequence below to perform calibration:
• Calibrate the steer angle.
• Calibrate the row tracers.
• Calibrate the steering (valves) (automatic or manual).
• Enter the turning circle.
The calibrated values are checked for plausibility. If a value is outside the valid range, the
error message
appears beside the calibrated value. The value cannot be saved.
• Start the engine and switch on the release switch "automatic steering system".
• Drive the machine at a speed of 0.7 km/h.
Fig. 207
The main menu 3 Maintenance is open
• Using the incremental encoder, choose the menu Calibration of automatic steering system.
• Press the incremental encoder.
To Next Page
Loading...
