Krone BiG X 770-3 - Page 319

Info centre "EasyTouch"
319
Display 2 “Terminating resistor CAN bus 2”
Fig. 243
In display 2 “Terminating resistor CAN bus 2”, the relay to switch the terminating resistor
installed in the CAN bus 2 can be switched on or off for extended diagnostics purposes. The
terminating resistor is switched on automatically if there is no AutoScan sensor installed on the
machine.
Mask description display 2 “terminating resistor CAN bus 2“
BMK
Mask display / symbols / description
22-R61
Condition of terminating resistor CAN 2.
Table 9
Switching actuators on/off
If all switching conditions have been met for the actuator test,
the softkeys
and are displayed and the displayed actuators are activated. They can
be switched on and off via number keys.
BMK
Symbol
Description
Switch on the
actuator
Switch off the
actuator
R61
Terminating resistor CAN2
Table 10