Settings
605
Setting the additional ventilation slots on the discharge accelerator for use with the corn
conditioner
Fig. 541
• Factory basic setting for use with corn conditioner: completely open
(With maize, no air travels upward through the corn conditioner to the discharge
accelerator. If the opening of the additional ventilation slot is too small, insufficient air is
supplied and the discharge capacity is reduced.)
Setting the additional ventilation slots:
• Loosen the wing nuts (1)
• Pull the wear plate (2) to the centre to the required position or remove it completely
• Tighten the wing nuts (1)
NOTE
If, in spite of this, the discharge capacity is still insufficient, an additional distance sheet can be
installed between the wear plate and the rear wall of discharge accelerator. This changes the
crop flow and the discharge capacity can increase.
To Next Page
Loading...
