17: Command Reference
EMG™ Edge Management Gateway User Guide 371
Not all EMG models will have all slots.
admin firmware bootbank
Syntax
admin firmware bootbank <1|2>
Description
Sets the boot bank to be used at the next EMG reboot.
admin firmware bootcount
Syntax
admin firmware bootcount <0|1>
Description
Configures bootcount parameter that control how many times the EMG has failed to boot. If this
value reaches Boot Limit, the EMG will switch to the alternate boot bank. The EMG will switch to
the alternate boot bank only once. For example, if it fails to boot Boot Limit times on bank 1, it will
automatically switch to bank 2; if it fails to boot Boot Limit times on bank 2, it will enter advanced
recovery mode. If Boot Count has reached Boot Limit, setting this value to 0 will enable the EMG
to boot again. Default is 0, range is 0 - 1.
admin firmware bootlimit
Syntax
admin firmware bootlimit <3-20>
Description
Configures bootlimit parameters that control how many times the EMG will fail to boot before
switching to the alternate boot bank. After the EMG fails to boot 2 times Boot limit (so it has
attempted to boot Boot Limit times on each bank), the EMG will go into advanced recovery mode,
which may require support from Technical Support to resolve so that the EMG can be booted
again. Default is 3 boots, range is 3 - 20.
admin firmware bootdelay
Syntax
admin firmware bootdelay <3-1800>
Description
Configures bootcount parameters that control how seconds the bootloader pauses before booting
the EMG. The default is 3 seconds and the range is between 3 and 1800 seconds.
To Next Page
Loading...
Need help?
General
