Lexmark MX81 series - Sensor (ADF Media Exit) Static Jam Service Check

Action Yes No
Step 5
Check the ADF transport motor for proper operation.
a Enter the Diagnostics Menu.
b Touch TESTS.
c Touch Transport Motor/Deskew Clutch.
d Touch either Motor Forward or Motor backward
e Perform test.
Does the ADF pick motor operate properly?
Go to step 7.Go to step 6.
Step 6
Check the ADF transport motor for proper connection.
Is the above component properly connected?
Replace the ADF rear
side drive parts pack.
Go to “ADF rear side
drive parts pack
removal” on page
472.
Replace the
connection.
Step 7
Place an undamaged document in the ADF, and perform a ADF test.
Does the error remain?
Replace the ADF
controller PCBA.
Problem solved.
Step 8
Perform a print test using the ADF.
Does the problem remain?
Contact the next
highest level of
support.
Problem solved.
Sensor (ADF media exit) static jam service check
Action Yes No
Step 1
Check the media size setup and tray guides for the ADF. Does the media
size, in use, match the size set for the ADF
Go to step 2. Replace the media, or
change the media size
setup.
Step 2
Check the sensor (ADF media exit) for proper operation.
a Enter the Diagnostics Menu.
b Touch SCANNER TESTS.
c Touch Sensor Tests.
d Observe the line "sensor (ADF media exit)."
Does the display on the operator panel change every time the sensing
area of the above sensor is interrupted or blocked?
Go to step 4.Go to step 3.
7463
Diagnostic information
129