Lexmark MX81 series - Duplex Removal (Mx71 X)

• “Media tray removal” on page 374
• “Media size actuator removal” on page 375
• “Pick roller assembly removal” on page 377
• “Sensor (duplex path) removal” on page 378
• “Sensor (tray 1 media out) removal” on page 379
• “Separator roller assembly removal” on page 381
• “Right frame extension (MX71x)” on page 381
• “Right frame extension removal (MX81x)” on page 383
Duplex removal (MX71x)
1 Remove the top cover. See “Top cover removal” on page 314.
2 Remove the left cover. See “Left cover removal (MX71x)” on page 301.
3 Remove the rear door. See “Rear door removal” on page 307.
4 Remove the rear lower cover. See “Rear lower cover removal” on page 309.
5 Remove the PCBA housing. See “PCBA housing removal” on page 394.
6 Remove the fuser access door. See “Fuser access door removal” on page 349.
7 Remove the duplex motor. See “Duplex motor removal” on page 345.
8 Remove the media tray. See “Media tray removal” on page 374.
9 Remove the pick roller assembly. See “Pick roller assembly removal” on page 377.
10 Remove the media feeder. See “Media feeder removal” on page 393.
11 Remove the two screws (A) securing the duplex to the machine.
12 Gently lay the printer on its side.
7463
Repair information
365