3 Remove the three screws (B) from the bottom of the left cover.
4 Pull the left cover, and remove.
Drawer controller PCBA removal
1 Remove the drawer assembly rear cover. See “Drawer assembly rear cover removal” on page 562.
2 Remove the drawer assembly left cover. See “Drawer assembly left cover removal” on page 563.
3 Disconnect all cables (J3, J4, J11, J10, J9, J8, J7, J6, and J1) from the controller PCBA, then remove the two screws
(A).
7463
Repair information
564
To Next Page
Loading...
