9 With a prying tool, release the spring to loosen the link (D).
10 Lift the media feeder and release the link holding the media feeder.
11 Ease the media feeder off the drawer, and remove.
Staple finisher/offset stacker option removals
• “Staple finisher/offset stacker option removal” on page 595
• “Stapler/offset stacker rear door removal” on page 595
• “Stapler/offset stacker left cover removal” on page 597
• “Stapler/offset stacker top cover removal” on page 599
• “Stapler/offset stacker spring with string removal” on page 601
• “Media stack flap (right) removal” on page 602
• “Media stack flap (left) removal” on page 603
• “Standard output bin LED removal” on page 606
• “Sensor (finisher/stacker bin media present) removal” on page 607
• “Tamper motor (right) removal” on page 608
• “Tamper motor (left) removal” on page 608
• “Tamper drive belt removal” on page 609
• “Paddle drive motor removal” on page 610
• “Stapler/offset stacker lower interface cable removal” on page 611
• “Stapler/offset stacker controller PCBA removal” on page 613
• “Sensor (bin full send) removal” on page 614
• “Sensor (bin full receive) removal” on page 615
7463
Repair information
594
To Next Page
Loading...
