4 Disconnect the cable (C) from the controller board, and remove the main cooling fan.
Main drive motor removal
1 Remove the imaging unit from the machine.
2 Remove the right cover. See “Right cover removal (MX71x)” on page 311.
3 Remove the rear lower cover. See “Rear lower cover removal” on page 309.
4 Remove the LVPS. See “LVPS removal” on page 403.
5 Remove the left cover. See “Left cover removal (MX71x)” on page 301.
6 Remove the PCBA housing. See “PCBA housing removal” on page 394.
7 Remove the harnesses from the clamp (A).
7463
Repair information
391
To Next Page
Loading...
