10 Disconnect the cable.
Toner add motor removal
1 Remove the right cover. See “Right cover removal (MX71x)” on page 311.
2 Remove the rear lower cover. See “Rear lower cover removal” on page 309.
3 Remove the LVPS. See “LVPS removal” on page 403.
4 Remove the left cover. See “Left cover removal (MX71x)” on page 301.
5 Remove the PCBA housing. See “PCBA housing removal” on page 394.
6 Remove the three screws (A) securing the toner add motor to the machine.
7463
Repair information
398
To Next Page
Loading...
