Media stack flap (right) removal
1 Remove the left cover. See “Stapler/offset stacker left cover removal” on page 597.
2 Remove the right cover. See “Stapler right cover removal” on page 617.
3 Remove the top cover. See “Stapler/offset stacker top cover removal” on page 599.
4 Remove the two screws (B) from the cover (A).
5 Move the media stack flap to the right to release the pins from the holes.
Note: The metal latch (C) may need to be flexed to release the pins.
7463
Repair information
602
To Next Page
Loading...
