Available options:
• Single Pass Erase—overwrites all data and the file system. This wipe is faster but less secure since it is possible to
retrieve the deleted data with forensic data‑retrieval techniques.
• Multi Pass Erase—overwrites all data without rewriting the file system. This wipe is DoD 5220.22-M compliant since
the deleted data is irretrievable.
Note: If the printer is reset while a disk wipe operation is executing, then Corrupt Disk appears upon regaining
power.
Wipe All Settings
This makes any sensitive information that may exist on the volatile or non-volatile storage of the device completely
indecipherable. When selected, the printer performs a non‑critical NVRAM reset and then reboots.
Font Sharpening
This setting allows a user to set a text point-size value below which the high‑frequency screens will be used when
printing font data.
To change the setting:
1 From the Configuration Menu, navigate to Font Sharpening.
2 To change the value, depending on the model, enter the numerical value or press the arrows, and then press
Submit.
3 Press Back or X to return to the Configuration menu.
A4 Fuser
The A4 fuser cannot fuse the entire right side of any print job that uses media wider than 8.27” (for example: letter or
legal). You can use the A4 Fuser setting to determine whether these images are clipped or compressed. Compression
is only in the X direction; scaling does not apply to the process (or Y) direction.
To change the setting:
1 From the Configuration menu, navigate to A4 Fuser.
2 Select from the available options to change the setting.
• Compress
• Clip
3 Depending on the printer model, press OK or touch to save the setting, or press X to return to the Configuration
Menu without saving any changes.
Require Standby
Note: This setting is available on the touch screen models only.
This setting determines whether Standby Mode is On or Off. The default is On.
7463
Service menus
261
To Next Page
Loading...
