Lexmark MX81 series - Toner Rubs off; Default Chapter; Paper Jams

Actions Yes No
Step 6
Replace the printhead. See “Laser printhead removal” on page 320.
Does this solve the problem?
The problem is solved. Contact your next level
of support.
Toner rubs off
Leading edge
Trailing edge
ABC
DEF
Actions Yes No
Step 1
Check if the fuser screws are tightly fastened.
Are they tightly fastened?
Go to step 2. Reseat the fuser, and
tighten the screws.
Step 2
Check the following fuser components for wear or damage:
• Gears
• Exit rollers
• Heat belt or hot roller
Are they free of damage?
Go to step 3. Replace the fuser. See
“Fuser removal” on
page 347.
Step 3
Check the cables on the LVPS.
Are the connections on the above component properly connected?
Contact the next level
of support.
Replace the LVPS. See
“LVPS removal” on
page 403.
Paper jams
• “Understanding jam numbers and locations” on page 52
• “200–201 paper jams” on page 54
• “Sensor (input) static jam service check” on page 58
• “Sensor (input) early arriving jam service check” on page 58
• “Sensor (input) never‑ or late‑arriving jam service check” on page 60
• “Sensor (input) late-leaving or did-not-clear jam service check” on page 61
• “Main drive motor control jam service check” on page 63
• “Printhead motor control jam service check” on page 63
• “Fuser drive motor control jam service check” on page 64
7463
Diagnostic information
51