e Loosen the adjustment screw again to tighten the belt.
f Tighten the adjustment screw again.
250/550-sheet media tray option removals (MX710 and
MX711)
• “250/550-sheet media tray option removal” on page 521
• “Media tray separation roller removal” on page 521
• “Media tray assembly removal” on page 521
• “Media tray front cover removal” on page 522
• “Drawer pick roller removal ” on page 522
• “Sensor (pick roll position) removal ” on page 522
• “Drawer assembly rear cover removal” on page 523
• “Drawer assembly left cover removal” on page 524
• “Drawer controller PCBA removal” on page 525
• “Drawer upper interface cable removal” on page 526
• “Drawer lower interface cable removal” on page 527
• “Drawer media feeder removal ” on page 528
• “Drawer transport motor removal” on page 530
• “Sensor (drawer pass through) removal ” on page 531
• “Sensor (pick) removal” on page 533
7463
Repair information
520
To Next Page
Loading...
