Lexmark MX81 series - Sensor (Narrow Media) Static Jam Service Check

Action Yes No
Step 7
Check the upper redrive for damage.
Is the above component free from damage?
Go to step 8. Replace the upper
redrive. See “Upper
redrive removal” on
page 363.
Step 8
Perform a print test, and check the upper redrive motor for proper
operation.
Does the above component operate properly?
Go to step 9. Replace the upper
redrive. See “Upper
redrive removal” on
page 363.
Step 9
Perform a print test.
Does the problem remain?
Contact the next
highest level of
technical support.
Problem solved.
Sensor (narrow media) static jam service check
Action Yes No
Step 1
Check the fuser for jammed media.
Is the fuser path free from jammed media?
Go to step 2. Remove any jammed
media.
Step 2
Check the sensor (fuser exit) for proper operation.
a Enter the diagnostic mode.
b Select Base sensor test.
c Observe the line item fuser exit.
Does the display on the control panel change every time the sensing area
of the above sensor is interrupted or blocked?
Go to step 4.Go to step 3.
Step 3
Check the above sensor for proper connection.
Is the above sensor connected properly?
Replace the fuser. See
“Fuser removal” on
page 347.
Go to step 4.
Reseat the connection.
Go to step 4.
Step 4
Perform a print test.
Does the problem remain?
Contact the next
highest level of
technical support.
Problem solved.
7463
Diagnostic information
71