Error code Description Action
200.45 Media reached the sensor (input), but did not
clear it within the specified time. (Media
source = Tray 4)
See “Sensor (input) late-leaving or did-not-clear jam service
check” on page 61.
Sensor (input) static jam service check
Action Yes No
Step 1
Check the media path for partially fed or jammed media.
Is the media path free from partially fed or jammed media?
Go to step 2. Remove any pre-
staged or jammed
media.
Step 2
Check the sensor (input) for proper operation.
a Enter the diagnostic mode.
b Select Base sensor test.
c Observe the line item input.
Does the display on the operator panel change every time the sensing
area of the above sensor is interrupted or blocked?
Go to step 4.Go to step 3.
Step 3
Check the above sensor for proper connection.
Is the above sensor connected properly?
Replace the Sensor
(input). See “Sensor
(input) removal” on
page 335.
Go to step 4.
Reseat the connection.
Go to step 4.
Step 4
Perform a print test.
Does the problem remain?
Contact the next
highest level of tech
support.
Problem resolved.
Sensor (input) early arriving jam service check
Action Yes No
Step 1
Check media origination.
Did the media originate from the MPF?
Go to step 2. Go to step 5.
Step 2
Check the MPF pick roller.
Is the MPF pick roller free of excess wear and contamination?
Go to step 3. Clean or replace the
MPF pick roller. See
“MPF pick roller
removal” on page
331.
7463
Diagnostic information
58
To Next Page
Loading...
