3 Turn the skew adjustment screw (B) appropriately - clockwise for negative skew or counterclockwise for positive
skew.
Note: Each full turn of the adjustment screw yields 0.6 mm of skew correction. The maximum adjustment is one
full turn either way.
4 After skew has been corrected, reinstall the front cover.
ADF skew adjustment (deskew roller)
1 Remove the ADF front cover. See “ADF front cover removal” on page 459.
2 Loosen the two screws (A) securing the adjusting bracket to the ADF frame.
7463
Repair information
289
To Next Page
Loading...
