8 Remove the two screws (D) securing the limit switch.
9 Disconnect the cable (J7) from the controller PCBA.
10 Route the cable off the stapler, and remove the stapler door close limit switch.
Note: Pay attention to the original routing of the cables.
Mailbox option removals
• “Mailbox assembly removal” on page 624
• “Mailbox top cover removal” on page 624
• “Mailbox rear door removal” on page 624
• “Mailbox right cover removal” on page 626
• “Mailbox spring with string removal” on page 627
• “Mailbox solenoid removal” on page 628
• “Mailbox left cover removal” on page 630
• “Mailbox controller PCBA removal” on page 631
• “Sensor (mailbox divert motor) removal” on page 633
• “Mailbox lower interface cable removal” on page 634
• “Mailbox upper interface cable removal” on page 636
• “Mailbox divert motor removal” on page 636
• “Mailbox media bin full flag removal” on page 638
7463
Repair information
623
To Next Page
Loading...
