Lexmark MX81 series - Feed Tests; Output bin Tests; Sensor Tests

To run the Feed test:
1 From the Diagnostics menu, navigate to:
Input Tray Tests > Feed Tests
2 Choose the input source. All installed sources appear.
3 Choose any of the following:
• Single—Feeds a single page.
• Continuous—Continuously feeds pages until X is pressed.
Sensor Tests
Use this test to determine if the input tray sensors are working correctly.
1 From the Diagnostics menu, navigate to:
INPUT TRAY TESTS > Sensor Tests
2 Select the input source. All installed sources appear.
Not all sensors appear for all trays. The following table indicates which tray sensors are available for each input
source:
Input source Empty
(Input tray empty
sensor)
Low
(Input tray paper low
sensor)
Pass through sensor
Tray 1
Tray 2
Tray 4
Tray 5
Multi‑purpose feeder
Envelope feeder
3 Manually actuate each sensor. The tray empty sensor can be actuated by hand; however, a sheet of paper can be
used to cover the pass through sensor.
4 Press X to exit the test.
OUTPUT BIN TESTS
Feed Tests
This test verifies that media can be fed to a specific output bin. No information is printed on the media.
To run the feed tests:
1 From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Feed Tests
2 Select the output bin into which you want the paper to exit. All installed output bins appear.
7463
Service menus
240