8 Remove the media feeder.
PCBA housing removal
Note: When removing the PCBA housing, the controller board will remain attached to the PCBA housing.
1 Remove the right cover. See “Right cover removal (MX71x)” on page 311.
2 Remove the rear lower cover. See “Rear lower cover removal” on page 309.
3 Remove the LVPS. See “LVPS removal” on page 403.
4 Remove the left cover. See “Left cover removal (MX71x)” on page 301.
5 Disconnect all of the cables from the controller board.
7463
Repair information
394
To Next Page
Loading...
