Environment
Printer Temperature and Humidity
• Operating
– Temperature: 60 to 90° F (15.6 to 32.2° C)
– Relative humidity: 8 to 80%
– Maximum wet bulb temperature: 73° F (22.8° C)
– Altitude: 9,500 ft. (0 to 2896 meters)
– Atmospheric pressure: 74.6 kPa
• Power off
– Temperature: 50 to 110° F (10 to 43.3° C)
– Relative humidity: 8 to 80%
– Maximum wet bulb temperature: 80.1° F (26.7° C)
– Altitude: 9,500 ft. (0 to 2896 meters)
– Atmospheric pressure: 74.6 kPa
• Ambient operating environment*
– Temperature: 60 to 90° F (15.6 to 32.2° C)
– Relative humidity: 8 to 80%
• Storage and shipping (packaged printer) with or without print cartridge
Temperature: -40 to 110° F (-40 to 43.3° C)
*In some cases, performance specifications (such as paper OCF, EP cartridge usage) are measured at an ambient
condition.
Processor
800 MHz, dual core
Security reset jumper
The Security Reset Jumper is available on all high-end printer and MFP models.
Each device contains a hardware jumper with which an administrator can:
• Erase all security templates, building blocks, and access controls that a user has defined (i.e. the factory default
configuration); or
• Force the value of each function access control to “No Security” (all security templates and building blocks are
preserved but not applied to any function).
Note: If the “Enable Audit ” setting in the Security Audit Log section of the “Security Menu ” is activated, the device
logs a message each time that the jumper is used.
A small lock icon identifies the jumper’s position on the RIP card. Also, to make it easier to separate the small yellow
plastic jumper from the 3-pin connector, a looped handle is attached to the top of the small yellow jumper that covers
the 3-pin connector.
7463
Appendix A: Printer specifications
761
To Next Page
Loading...
