Action Yes No
Step 7
Remove the staple finisher assembly from the printer. Check the feed
rollers and gears under the staple finisher.
Is if free of damage?
Go to step 8. Replace the staple
finisher assembly. Go
to “Staple finisher/
offset stacker option
removal” on page
595.
Step 8
Open the top cover, check the left media stack flap:
• for damage
• if it is not dislodged from its original position
• if it has no problem moving when manually actuated
Is the above component ok?
Go to step 9. Replace the left media
stack flap. Go to
“Media stack flap (left)
removal” on page
603.
Step 9
Check the right media stack flap:
• for damage
• if it is not dislodged from its original position
• if it has no problem moving when manually actuated
Is the above component ok?
Go to step 10. Replace the right
media stack flap. Go to
“Media stack flap
(right) removal” on
page 602.
Step 10
Open the left cover, reseat all connectors on the controller PCBA and then
POR the machine.
Does the error remain?
Replace the controller
PCBA. Go to “Stapler/
offset stacker
controller PCBA
removal” on page
613.
If the error persists,
then replace the staple
finisher. Go to “Staple
finisher/offset stacker
option removal” on
page 595.
The problem is solved.
7463
Diagnostic information
193
To Next Page
Loading...
