6 Remove the output bin sensor cover. See “Output bin sensor cover removal” on page 356.
7 Remove the sensor (standard bin full) with actuator. See “Sensor (standard bin full) removal” on page 356.
8 Remove the standard bin cover. See “Standard bin cover removal (MX71x)” on page 357.
9 Remove the control panel. See “Control panel removal (MX71x)” on page 414.
10 Disconnect the left recoil spring.
11 Remove the e-clip (A) securing the pin to the left control panel hinge.
12 Remove the pin (B).
13 Remove the controller board access shield. See “Controller board access shield removal” on page 388.
7463
Repair information
433
To Next Page
Loading...
