Error code Description Action
202.03 The media is late reaching the sensor (fuser
exit) within the specified time
See “Sensor (fuser exit) late-arriving jam service check” on
page 69.
202.05 The media reached the sensor (fuser exit) but
did not clear it within the specified time
See “Sensor (fuser exit) late-leaving jam service check” on
page 68.
202.07 The media reached the sensor (fuser exit) but
did not clear it within the specified time
See “Sensor (fuser exit) late-leaving jam service check” on
page 68.
202.13 The media is late reaching the sensor (fuser
exit) within the specified time
See “Sensor (fuser exit) late-arriving jam service check” on
page 69.
202.14 Expected banner sheet (assumed wide) not
detected by narrow media sensor—possible
accordion jam, unsupported narrow banner
media, or missing signal
See “Sensor (narrow media) late arriving jam service check” on
page 70.
202.16 Page at fuser nip before fuser started
ramping toward desired area. Indicates code
may be receiving more hall interrupts than
intended
See “Fuser drive motor control jam service check” on page 64.
202.17 Page at fuser nip before fuser reached
acceptable operating temperature. Page
arrived at fuser earlier than expected, so it
was probably staged
See “Fuser drive motor control jam service check” on page 64.
202.22 Cartridge Motor—Motor under‑speed error.
Motor made it to closed loop at a steady
state, but then detected speed was below
threshold
See “Fuser drive motor control jam service check” on page 64.
202.28 The sensor (fuser exit) rebounded upon being
released by the trailing edge of the media
See “Sensor (fuser exit) miscellaneous jam service check” on
page 72.
202.31 Media remains on the sensor (narrow media)
during the warm‑up sequence
See “Sensor (narrow media) static jam service check” on
page 71.
202.32 The media reached the sensor (fuser exit) but
did not clear it within the specified time
See “Sensor (fuser exit) late-leaving jam service check” on
page 68.
202.33 Expected wide page not detected by sensor
(narrow media), possible accordion jam or
missing signal
See “Sensor (narrow media) late arriving jam service check” on
page 70.
202.43 The media is late reaching the sensor (fuser
exit) within the specified time
See “Sensor (fuser exit) late-arriving jam service check” on
page 69.
202.45 Media remains on the sensor (fuser exit)
during the warm‑up sequence
See “Sensor (fuser exit) static jam service check” on page 68.
202.49 Fuser info chip error See “Fuser ID chip control jam service check” on page 72.
7463
Diagnostic information
67
To Next Page
Loading...
