6 Insert the standard tray.
7 To clear the message and continue printing, select Next > > Clear the jam, press OK > .
230 paper jams
Error code Description Action
230.01 Media remains on the sensor (duplex path)
during the warm up sequence
See “Sensor (duplex path) static jam service check” on
page 77.
230.02 The media reached the sensor (duplex path)
sooner than the specified time
See “Sensor (duplex path) early arriving jam service check” on
page 78.
230.03 The media is late reaching the sensor (duplex
path) within the specified time
See “Sensor (duplex path) never‑ or late‑arriving jam service
check” on page 78.
232.03 The media is late reaching the sensor (input)
within the specified time when exiting the
duplex
See “Sensor (input) never-arriving jam (exiting duplex) service
check” on page 82.
230.05 The media reached the sensor (duplex path)
but did not clear it within the specified time
See “Sensor (duplex path) late leaving jam service check” on
page 79.
230.07 The media reached the sensor (duplex path)
but did not clear it within the specified time
See “Sensor (duplex path) late leaving jam service check” on
page 79.
230.20 Took too long to ramp up duplex motor See “Duplex control jam service check” on page 80.
230.21 Duplex motor stopped after successful start
up
See “Duplex control jam service check” on page 80.
230.22 Duplex motor under‑speed error See “Duplex control jam service check” on page 80.
7463
Diagnostic information
76
To Next Page
Loading...
