Tray not ready service check
Action Yes No
Step 1
Check the size sensing fingers on the media tray for damage, and
if necessary, replace the media tray assembly.
Does the problem remain?
Go to step 2. Problem is solved.
Step 2
Check the switch (media size) for proper connection, and if
necessary, replace the switch (media size). See
“Switch (media
size) assembly removal ” on page 282.
Does the problem remain?
Contact next level of
support.
Problem is solved.
Empty tray pick attempted service check
Action Yes No
Check the media out actuator for damage, and if necessary,
replace the media out actuator. See
“Tray roller catch assembly
removal” on page 342.
Does the problem remain?
Contact next level of
support.
Problem is solved.
HCIT tray lift motor stalled failure service check
Action Yes No
Step 1
Properly insert the HCIT media tray assembly into the machine.
Does the problem remain?
Go to step 2. Problem is solved.
Step 2
Check the HCIT tray lift motor assembly for binding or damage,
and if necessary, replace the HCIT tray lift drive motor assembly.
Go to
“High capacity input tray (HCIT) tray lift drive motor
assembly removal” on page 382.
Does the problem remain?
Contact next level of
support.
Problem is solved.
4062
Diagnostic information
130
To Next Page
Loading...
