4 Press down on the staple guard until it snaps into place.
5 Push the cartridge holder firmly back into the stapler unit until the cartridge holder clicks into place.
6 Close the stapler door.
7 Press .
280 error messages
Error code Description Action
28x.25 Invalid ejector motor manager status (staple
finisher)
A software failure has occurred with the output
option.
Go to
“Invalid ejector motor manager status
(staple finisher) service check” on page 152.
28x.26 Timer 0 overflow (1 ms timer did not get serviced
for an entire 1 ms) (staple finisher)
A software failure has occurred with the output
option.
28x.27 Invalid paddle motor manager status (staple
finisher)
A software failure has occurred with the output
option.
28x.28 Invalid main motor manager state (staple finisher)
A software failure has occurred with the output
option.
28x.29 Sensor (stapler pass through) lingering jam (staple
finisher)
The media reached the sensor (stapler pass
through) but did not clear it in the specified time.
Go to
“Sensor (stapler pass through) lingering
jam service check” on page 153.
28x.30 Page ID complete not clear (staple finisher)
A software failure has occurred with the output
option.
Go to
“Invalid ejector motor manager status
(staple finisher) service check” on page 152.
4062
Diagnostic information
147
To Next Page
Loading...
