Order of sheets that are fed Output bin
11 Bin 10
12 Bin 10
13 Bin 9
14 Bin 8
15 Bin 7
16 Bin 6
17 Bin 5
18 Bin 4
19 Bin 3
20 Bin 2
21 Bin 1
22 Standard bin
Note: The printer continuously feeds pages until the Stop button is pressed.
2 Press the Back button to return to OUTPUT BIN TESTS.
Sensor Test (standard bin)
This test
verifies
whether the standard bin sensor is working correctly.
1 From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Sensor Test > Standard Bin
Note: The current state of the sensor appears on the control panel display.
2 Manually actuate the sensor to make it toggle between Open and Closed or between empty and full,
depending on the printer model. If the sensor does not toggle, then the sensor is malfunctioning.
3 Press the Stop button to exit the test.
Sensor Test (output expander)
This test determines whether the bin sensor for the output expander is working correctly.
Note: This is applicable only in models T650, T652, and T654.
1 From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Sensor Test > Output Bin [x]
Notes:
• x represents the number of the output option to be tested.
• The printer display would indicate that the pass through sensor (passThru), bin full sensor (Full), or bin
near full sensor (NearFull) is open.
2 Manually actuate the sensor to make it toggle between Open and Closed. If the sensor does not toggle,
then the sensor is malfunctioning.
4062
Service menus
246
To Next Page
Loading...
