3 Press the Back or Stop button to exit the test.
Sensor Test (high capacity output stacker)
This test determines whether the bin sensor for the output expander is working correctly.
Note: This is applicable only to models T650, T652, and T654.
1 From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Sensor Test > HC Bin [x]
Notes:
• x represents the number of the output option to be tested.
• The printer display would indicate that the top position sensor (TP), pass through sensor (passThru),
bin full sensor (Full), or bin near full sensor (NearFull) is open.
2 Manually actuate the sensor to make it toggle between Open and Closed. If the sensor does not toggle,
then the sensor is malfunctioning.
3 Press the Back or Stop button to exit the test.
Sensor Test (5‑bin mailbox)
Note: This is applicable only to models T650, T652, and T654.
1 From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Sensor Test > Output Bin [x]
Note: x represents the number of the output option to be tested.
2 Manually actuate passThru sensor to make it toggle between Open and Closed and the empty sensor to
make it toggle between Normal, Full, and NearFull. If the sensor does not toggle, then the sensor is
malfunctioning.
3 Press the Back or Stop button to exit the test.
Deflector Test
Note: This is applicable only to models T650, T652, and T654.
This test verifies the functioning of each of the 5‑bin mailbox output media deflectors. If more than one 5‑bin
mailbox is installed, then all deflectors are tested.
From the Diagnostics menu, navigate to OUTPUT BIN TESTS > Deflector Test. The test runs once and then
stops.
4062
Service menus
247
To Next Page
Loading...
