Action Yes No
Step 7
Perform a print test and check the pick arm assembly for the
appropriate media tray if media is properly picked and advanced
out of the tray. If necessary, replace the appropriate pick arm
assembly. See
“T656 operator panel door assembly removal” on
page 310.
Does the problem remain?
Go to step 8. Problem is solved.
Step 8
Perform a print test and check the main motor assembly if media
is properly transported through the pass-thru areas of the media
trays. If necessary, replace the main drive motor assembly. See
“Output cover assembly removal” on page 333.
Does the problem remain?
Go to step 9. Problem is solved.
Step 9
Perform a print test using the appropriate input tray, and if
necessary, replace the input option.
Does the problem remain?
Contact next level of
support.
Problem is solved.
Sensor (duplex input) late jam service check
Action Yes No
Step 1
Open and then properly close the rear door assembly.
Does the problem remain?
Go to step 2. Problem is solved.
Step 2
Open and then properly close the fuser access door.
Does the problem remain?
Go to step 3. Problem is solved.
Step 3
Remove obstructions in the internal duplex media path.
Does the problem remain?
Go to step 4. Problem is solved.
Step 4
Check the redrive assembly for damage, and if necessary, replace
the redrive assembly. See
“5-bin mailbox rear door assembly
removal” on page 343.
Does the problem remain?
Go to step 5. Problem is solved.
4062
Diagnostic information
99
To Next Page
Loading...
