ASSEMBLING THE W INDROWER
CAUTION
Check to be sure a ll bystanders have cleared t he area.
2. Start the engine and activate the HEADER DOWN
button (A) on the ground speed lever (GSL) to fully
retract header lift cylinders.
Figure 3.162: Ground Speed Lever
3. Activat e
theREELUPswitch(A)ontheGSLtoraise
the cente
r-link until the hook is above the attachment
pin on the
header.
IMPORTAN
T:
If t he ce
nter-link is too low, it may contact the
header a
s the windrower approaches the header
for hook
up.
Figure 3.163: Ground Speed Lever
4. Drive t
he windrower slowly forward until the boots (A)
enter t
he header legs (B). Continue driving slowly
forwa
rd until lift linkages contact the support plates in
the he
ader legs and the header nudges forward.
5. Ensur
e the lift linkages are properly engaged in the
heade
r legs and are contacting the support plates.
Figure 3.164: Header Leg and Boot
147962 100 Revision A
To Next Page
Loading...
