MacDon M Series - Activating the Double Windrow Attachment (DWA)

CAB DISPLAY MODULE (CDM)
4.4.12 Activa
ting the Double Windrow Attachme nt (DWA)
NOTE:
• Follow this procedure if installing the DWA; however, refe r to the DWA manual if you require additional installation
instructions.
• Follow this p ro cedure if installing a drive manifo ld (MD #1395 0 8).
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrowto select YE S. PressSELE CT (C).
• SET K NIFE SPEED? is displayed on the upper line.
Figure 4.
118: M155 CDM Programming Buttons
Figure 4.119: M205 CDM Programming Buttons
147962 204 Revision A