List of Revisions
The following
list provides an account of major changes from the previous version of this document.
Summary of Ch
ange
Location
Changed measurement format so that metric
measurements appear first followed by imperial in
parenthesis.
Revised figure titles for clarity.
Corrected
general grammar and punctuation.
Throughout the book
Added paragraph stating that this instruction is also
available in Russian.
Introduction, page i
Updated
declarations of conformity.
• EC Decla
ration of Conformity—Windrower Lift Sling,
page ii
• EC Decla
ration of Conform ity—Windrower
Assembl
y Supports, page iv
Added ne w section f or battery safety. 1.3 Battery Safety, page 4
Added footnote to lift sling part number stating that it is
not sold separately.
• 2.2.1 Moving to Assembly Area: Crane Method, page
8
• 3.2.1 Lifting Windrower onto Stand: Crane Method,
page 28
Updated illustrations to show new battery hold-down .
• 3.7 R
emoving Batte ry Sh ip ping Sh ield, p ag e 61
• 3.13
.1 Connecting Batteries on an M205 or M155,
pag
e72
Corrected step to attach red positive cable terminals to
positive posts (C), which was erroneously referenced
as (A).
3.13.2 Connecting Batteries on an M105, page 73
Removed reference to M200 and extra hose in the
Note under Step 2.
3.
6.2 Ins tallin g Hydraulics on an M155, page 43
U
pdated procedure to show location of fuse box.
3.8 Unpacking Ignition Keys, page 62
Updated illustration to show new safety prop handle
and decal.
Reorganized sections for clarity.
Throughout 3.21 Attaching Headers, page 97
Added Hydraulic Union kit (MD #166844) to table of
kits that may be required to attach a D-Series Header
to an M205 Self-Prope lle d Windrower.
3.21.2 Attaching a D-Series Header, page 98
Added note recommending 18.4 x 26 drive tires when
attaching 13-ft R85 headers to the M155 or M205.
3.21.4 Attaching an R-Series Header, page 132
147962
vi
Revision A
To Next Page
Loading...
