MacDon M Series - Predelivery Checklist

Predelivery Checklist
Perform these checks and adjustments prior to delivery to your Customer. The completed checklist should be
retained by either the Operator or the Dealer.
CAUTION
Carefully follow the instructions given. Be alert for safety related messages that bring your attention to
hazards and unsafe practices.
Windrower Serial Number: Engine Serial Number:
Table 1 M-Series Self-Propelled Windrower Predelivery Checklist – Export

Item
Reference
Check for shipping damage or missing parts. Be sure all
shipping dunnage is removed.
—
Check for loose hardware. Tighten to required torque. 6 Reference, p age 35 7
Check tire air pressures and adjust as required. 5.3.1 Check ing Tire Pre ssu res, p age 322
Check final drive hub lubricant level.
5.2 Checking and Adding Wheel Drive Lubrican t
Level, page 321
Check engine coolant level and strength at reserve tank. 5.7 Ch ecking Engine Coolant, pag e 329
Check air cleaner and clamps. 5.4 Checking E ngine Air Intake, pag e 324
Check hydraulic oil level and check for leaks along lines. 5.5 Checking Hydraulic Oil, page 327
Check fuel separator for water a nd foreign material. Drain
and clean as necessary. Add fuel.
5.6 Checking Fuel Separator, page 328
Check gearbox lubricant level (M155 and M205).
5.8 Checking Gearbox Lubricant L evel on an
M155/M205, page 330
Check tension of air conditioning compressor belt.
5.9 Checking Air Conditioning (A/C) Compressor
Belts, page 331
Check that machine is completely lubricated.
3.22 Lubricating the Windrower, page 150
Check neutral interlock system. 5.10 Check ing Safety System , page 332
Check engine oil pressure indicator light at cab d isplay
module (CDM).
5.11.1 Checking Engine Warning Lights, page
336
Start engine and run to operating temperature. 5.11.3 Checking Windrower Startup, page 337
Check CDM for operation.
5.11.5 Checking Ga uges and Cab Display
Module (CDM) Display, page 338
Check Operator’s Prese nce System.
5.11.8 Checking Operator's Presence System,
page 341
Check alternator c harge rate on CDM. 5.11.7 Checking Electrical System, page 3 40
Check fuel gauge/indicator for operation.
5.11.5 Checking Ga uges and Cab Display
Module (CDM) Display, page 338
Check that air conditioning is functioning properly.
5.11.12 Checking Air Conditioning (A/C) and
Heater, page 35 0
147962 379 Revision A