ASSEMBLING THE W INDROWER
3.22 Lubricating the Windrower
For grease specification, refer to 6.4 Lubricants, Fluids, and System Capacities, page 374.
3.22.1 Lubrication Procedure
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator ’s seat for any reason.
1. Wipe grease fitting with a clean cloth be fo re greasing to avoid injectin g d irt a nd grit.
2. Inject grease through fittingwithgreasegununtilgreaseoverflows fitting. Do NOT overgrease wheel bearings.
3. Leave excess grease on fitting to keep out dirt.
4. Repla ce any loose or broken fittings immediately.
5. Remove and thoroughly c lean any fitting that will not take grease. Also clean lubricant passageway. Replace
fitting, if ne ce ssary.
147962 150 Revision A
To Next Page
Loading...
