CAB DISPLAY MODULE (CDM)
4.2.2 Changin
g the Windrower Display Units
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
Figure 4.12: M105 CDM Programming Buttons
Figure 4.13: M155 CDM Programming Buttons
Figure 4.14: M205 CDM Programming Buttons
147962 160 Revision A
To Next Page
Loading...
