CAB DISPLAY MODULE (CDM)
4.7.3 Display
ing Header Sensor Input Signals
You can display individual sensor input signals in the event of a m alfunction or as part of a troubleshooting routine.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
NOTE:
• For the M105 Self-Propelled Windrower, the header MUST be attached to the windrower to perform this
procedure.
• For the M105 Self-Propelled W indrower, displaying knife, reel, and center-link readings require installation of
the optional Expansion Module (MD #B4666). For more information, refer to the windrower operator ’s manual
or the w indrower technical manual.
147962 260 Revision A
To Next Page
Loading...
